OREANDA-NEWS. September 14, 2015. International automotive supplier Continental is extending its 48 V mild hybrid system with a further component: The Electrically Heated Catalyst EMICAT® for 48 V electrical systems reduces catalyst light-off time for both gasoline and diesel engine vehicles, which means that the catalyst begins reducing emissions sooner. For a gasoline engine, this helps to reduce cold-start emissions of hydrocarbons (HC) and particulates. In the case of diesel engines, the benefits also include reduced CO and NOx emissions. The EMICAT® also supports more extensive use of fuel-saving operating strategies such as coasting with the engine switched off. The rapid electrical heating of the catalytically coated structure brings the catalyst up to operating temperature almost as soon as the driver presses the gas pedal again. “The electrically heated catalyst for 48 V electrical systems allows highly efficient operating strategies to be implemented for the internal combustion engine while at the same time supporting compliance with emissions standards in day-to-day operation,” said Jos? Avila, Member of the Executive Board of Continental AG and President of the Powertrain Division.

In the 48 V hybrid vehicle, the electricity used to power the heating disc of the EMICAT® comes from energy recuperation. In other words, there is no longer any need for engine-based catalyst heating. The catalyst’s faster light-off time means that it is possible to shut down the engine sooner and more frequently – for engine-off coasting and enhanced start-stop functionality. These advantages allow the EMICAT® to offer fuel savings of between 3 and 4% in conjunction with a 48 V hybrid system.

Reduced emissions as well with cold exhaust

This new 48 V electrical consumer complements the 48 V electrical system of mild hybrid vehicles. In this type of vehicle in particular, switching off the internal combustion engine when it is not really needed is an important strategy for efficient operation.

The scope for such a strategy was demonstrated by Continental in an 82-kilometer test drive with the 48 Volt Eco Drive demonstration vehicle, where it was found that the engine could be switched off and decoupled for 22% of the total distance. On the urban sections of the route, featuring 30 different urban cycles, this proportion rose to approximately 30%. Of course, when an engine spends a lot of time switched off to save fuel, it tends to cool down. When operating at low speeds or with frequent overrun cut-off, this is particularly true of diesel engines. In such driving situations, a conventional catalytic converter can stop working. When reducing CO2 emissions, it is important to avoid this conflict of interest. “Frequent engine shutdowns are good for reducing CO2 emissions, but bad for downstream emissions control, where a continuous supply of hot exhaust gas is required. Using the EMICAT® as part of the 48 V architecture resolves this conflict,” said Rolf Br?ck, who heads up the Catalyst and Filter Product Line at the Powertrain Division’s Fuel & Exhaust Management Business Unit. An added benefit is that if, during a coasting phase, the driver has a change of mind and decides to accelerate, there is virtually no time lag before the EMICAT® starts reducing emissions again.

Intelligent operating principle means lower electricity consumption

In a hybrid vehicle too, electricity is a valuable commodity, and the EMICAT® ensures that it is used economically. A short heating cycle (power consumption 3-3.5 kW) is sufficient to get the heated disc and catalytically coated inner structure up to operating temperature, at which point the catalyst can function even with cold exhaust gas. “There is no need to heat the exhaust gas, just the catalyst structure itself. This makes the EMICAT® an efficient system that can be optimally integrated into a 48 V architecture,” said Br?ck.